Thorough preparation is essential to ensure a good finish. Contractors might have to fill cracks or holes and remove old paint if it is badly worn, peeling or flaking. They remove all paint and apply a suitable primer to the bare surface. If the existing paint is in reasonable condition, they clean it and rub it with abrasive material to provide a key for the new paint. On new surfaces, such as bare wood or fresh plaster, they apply a suitable seal, followed by a primer coat. House Painting Wheat Ridge, CO
For bigger houses or for faster work on smaller ones, rent a high-pressure spray cleaner. This device attaches to your home's water-supply system and puts out a jet of water at a pressure of about 600 pounds per square inch. It is equipped with a handheld wand tipped with a trigger-activated nozzle. The pressure is high enough to dislodge not only stubborn dirt, mildew, stains, and dried-on sea-spray salt, it's enough to remove peeling paint. In fact, if the jet nozzle is held too close to the surface it can even peel off perfectly sound paint, split open shingles, and drill a hole in siding. So follow the manufacturer's directions and wear goggles and protective clothing.
The only time it's acceptable to mix water in the paint is when you're using a deep or ultra deep base paint to reduce its stickiness, which is rare with new paint technology. Dark primary colors are composed almost entirely of tint that makes it very hard to work with without adding water. (You never use a sprayer and need to thin paint.?) If i was still in the industry I'd take the time to make a better article than this. Take this for a grain of slat. Use a reputable painter or someone you know you can trust or has been referred to you by someone you trust. I wouldn't hire anyone I had to watch like a hawk to make sure they're not screwing me.
The house bath may reveal nails that have popped out of the siding or rusting nail heads that have left streaks of rust on exterior walls. If so, use sandpaper or steel wool to clean the nail heads. On clapboard siding, use a nail set to recess the nail head about ⅛ inch below the surface of the wood. Dab on a coat of rust-inhibiting primer (unless the nail is aluminum or nonrusting galvanized steel), and let it dry. Then fill the nail hole with spackle or putty. When the filler is dry, give it a coat of primer. For flathead nails, which cannot be recessed, sand the heads until they're shiny, and coat with primer.

Home Painter Near Me Wheat Ridge Colorado


When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.

Your home is one of your most valued investments. When you hire a painting contractor, you deserve the best workmanship, paint quality and attention to detail available. Locally owned and operated for over 18 years, Brogan’s Home Painting offers the best residential painting contracting services in the Kansas City region, including Johnson County. Based in Overland Park, Kansas, owner Ed Brogan provides personalized service and is attentive to the details of your unique painting needs. Brogan’s Home Painting provides precise and timely estimates, honest and dependable service, and satisfaction guaranteed. If you need an estimate or consultation, give Ed Brogan a call today.

Cost Of House Painting Wheat Ridge Colorado

×